EST2 System Operations Manual 2.1
Chapter 2
Operating panel devices
Summary
Chapter 2 discusses the procedures for reading and operating
devices located at the fire alarm control panel.
Content
Operating the 2-LCD • 2.3
Reading status LEDs • 2.4
Operating control switches • 2.4
Scrolling message review switches • 2.5
Making keypad entries • 2.6
Selecting system functions on the 2-LCD • 2.7
Reading 2-LCD messages • 2.8
Current time • 2.8
Messages waiting • 2.8
Event type • 2.8
Event time • 2.9
Event address • 2.9
Event message • 2.9
Acknowledging prioritized messages • 2.10
Responding to off-normal conditions • 2.11
Fire alarms • 2.11
Supervisory points • 2.11
Trouble conditions • 2.12
Monitor points • 2.12
Maintenance message • 2.13
Verification message • 2.13
Initiating a drill test • 2.15
Checking system status • 2.16
Viewing the general status screen • 2.16
Viewing the loop status screens • 2.17
Viewing the field panel status screen • 2.18
Viewing the Relay/LED status screen • 2.19
Viewing disabled device status • 2.19
Programming system functions • 2.22
Setting the system date • 2.22
Setting the system time • 2.22
Changing system passwords • 2.22
Programming the communications class • 2.23
Restarting system devices/functions • 2.24
Reconfiguring SLC1 and SLC2 • 2.24
Enabling system functions • 2.25
Enabling a zone • 2.25
Enabling a message • 2.25
Enabling a time control • 2.25
Enabling an RS-485 channel • 2.26
To Next Page
Loading...
