Need help?Do you have a question about the EDWARDS SYSTEMS TECHNOLOGY EST2 and is the answer not in the manual?
Explains how to use the System Operations Manual effectively.
Details the practices and conditions used throughout the manual.
Outlines the typical format for activating system actions.
Covers the procedures for using the 2-LCD interface on the fire alarm panel.
Details the functions and indicators of the panel's physical control switches and LEDs.
Explains how to input information using the 2-LCD keypad.
Describes how to interpret and understand messages displayed on the 2-LCD.
Provides steps for handling fire alarms, supervisory, and trouble conditions.
Explains how to view system status screens on the 2-LCD.
Covers setting the system date, time, and passwords.
Explains how to initiate and end system test functions.
Details the operation of auxiliary devices like 2-MIC, 2-TEL, and SIGA-MDM.
Details the operation of remote annunciators like 2-SMDN, 2-CMDN, 2-LSRA.
Summarizes controls and indicators for various remote annunciator types.
Covers the operation of SAN series annunciators, including the 2-SANCOM.
Describes the supervised microphone and tone generator module.
Explains the operation, indicators, and controls of the PT-1S form printer.
Explains the operation, indicators, and controls of the RSAN-PRT strip printer.
Provides guidance on preparing and mounting operator instruction sheets.
Sample instructions for operating the fire alarm control panel without comms equipment.
Sample instructions for operating the panel with emergency communications equipment.
General| Type | Fire Alarm Control Panel |
|---|---|
| Operating Temperature Range | 32°F to 120°F (0°C to 49°C) |
| Zones | 2 |
| Maximum Number of Devices | 250 |
| Maximum Number of Zones | 2 |
| Communication Protocol | Proprietary |
| Power Supply | 120/240 VAC, 50/60 Hz |
To Next Page
