Operator instructions
EST2 System Operations Manual A.3
Installed By:
Location:
Per NFPA Standard:
For Service Contact:
Inspected By:
Power Supply:
Primary
Location
Fuses
Secondary
Type
Specs.
72, Ch 3 - Local
72, Ch 4 - Auxiliary
72, Ch 4 - Remote Sta.
72, Ch 4 - Proprietary
72, Ch 4 - Central Sta.
Dated:
Date:
STDOP007.CDR
Normal Condition:
Alarm Condition:
Note:
Supervisory Condition:
Trouble Condition:
Monitor Condition:
Fire Drill:
The Power LED (green) is on. All other LEDs are off.
The Alarm LED (red) turns on, the display shows the alarm location
and zone, and the internal buzzer pulses.
To view other alarm messages: Press the ALARM review switch (down arrow).
To silence audible devices: Press the Alarm Silence switch.
To reset the system: Find the cause of the alarm condition, correct it, and press the
Reset switch.
Each new
The Supervisory LED (yellow) turns on, the display shows the
supervisory condition, location, and zone, and the internal buzzer pulses.
To view other supervisory messages: Press the SUPVR review switch (down arrow).
To silence buzzer: Press Local Silence switch.
To clear the system: Find ress
the Reset switch.
The system Trouble LED (yellow) turns on, the display shows the
trouble location and zone, and the internal buzzer pulses.
To view other trouble messages: Press the TRBLE review switch (down arrow).
To silence the buzzer: Press the Local Silence switch.
To clear the system: Find the cause of the trouble and correct it. The system
automatically clears itself upon correction of trouble condition.
The Monitor LED (yellow) turns on, the display shows monitor
conditions, and the internal buzzer pulses during a non-fire alarm condition.
To view other monitor conditions: Press the MONTR review switch ( down arrow).
To clear system: The system automatically clears itself upon restoration of monitor
condition.
Notify the fire department before you run the test. All audible and visual
notification appliances will operate during a drill.
To drill all notification appliances: Press the Drill switch.
To end the drill: Press the Drill switch a second time, or press Alarm Silence.
Frame these instructions and mount them next to the fire alarm control panel. For
additional information, See the .
the cause of supervisory condition, correct it, and p
System Operations Manual
alarm will resound the audible devices, but you cannot resound
them by pressing the Alarm Silence switch a second time.
Fire Alarm Control Panel Operating Instructions
Figure A-1: Fire alarm control panel operating instructions
To Next Page
Loading...