EDWARDS SYSTEMS TECHNOLOGY EST2 - Using this manual

Introduction
1.2 EST2 System Operations Manual
Using this manual
Chapter overview
The System Operations Manual divides the operation of the fire
alarm system into three categories:
• Panel devices
• Remote devices
• Peripheral devices
Operating panel devices
The panel devices include modules, which mount inside the fire
alarm control panel and provide operator interface with the
system. All of the following operator interface devices mount in
the fire alarm control panel:
•2-LCD
• LED/switch modules
•2-MIC
•2-TEL
•SIGA-MDM
The explanation for each device usually includes a picture and
one or two tables, which describe the controls and indicators on
it. The 2-LCD, however, provides the detailed messages and an
extensive amount of operator control over the system. Therefore,
the 2-LCD requires a systematic description of its controls and
an explanation of the procedures for using it.
Operating remote devices
Remote devices provide operator interface at locations away
from the fire alarm control panel. Remote operator interface
devices include:
• 2-CMDN(-C)
• 2-LSRA(-C)
• 2-SANCOM
• 2-SMDN(-C)
•ISP-96-2
•ISP-96-3
• SAN-MICII
•SHO-4
•SLU-16
•SWU-8/3
Again, the explanation for each device usually includes a picture
and one or two tables, which describe the controls and indicators
on it. The notable exceptions include the SWU-8(/3), the SHO-4,
the ISP-96-2, and the ISP-96-3 because of their toggle switch
options.