Operating panel devices
EST2 System Operations Manual 2.9
Event time
The event time also appears in a twenty-four hour format, but it
only indicates the time the event occurred and does not change.
Event address
Each address in the system consists of the following
components:
• Panel addresses (01 or 63)
• Zone numbers (01 - 96)
The event address in Figure 2-2 signifies that the Main
Controller Module (MCM) received an alarm condition from a
detector at address 01.
Event message
The message below the event address indicates the specific
location of the condition and any other relevant information. The
programmer customizes the message in the 2-SDU.
See System service procedures, in the Installation and Service
Manual, for a complete table of system fault messages.
To Next Page
Loading...
