Edwards SCU-801

SCU-801 Control Unit for Turbomolecular Pump
MT-95E-001-A
Page 29
3
INSTALLATION
3.9.3 Change of data after tuning
The user setting may be changed because of the change of the configuration of the STP pump and
STP control unit after "CAUTION" message is displayed.
Confirm the setting shown in Table 7 after tuning, and reconfigure the setting when the user setting has
changed.
For the setting confirmation, see Section 3.10, "Confirmation mode", for the setting method, see
Section 3.11, "Parameter set mode".
Items
Factory setting
(reference)
Remarks
Remote mode
I/O Remote
Rotational speed
Rated speed
Varies according to STP pump type.
TMS function
DISABLE
ENABLE : Built-in TMS control
specification
External : External TMS control
specification
Advanced : Both built-in and external
TMS specification
Inhibit function
DISABLE
Emergency vent valve
DISABLE
Second damage limit
ENABLE
Pump air-cooling fan
DISABLE
Warning function
Damage point
ENABLE
Imbalance
ENABLE
Pump run time
DISABLE
Pump overload
DISABLE
Serial port
Baud rate
9,600 bps
COM1, COM2
Bit length
8
Stop bit
1
Parity
None
Serial port COM1 driver type
RS232
Serial port COM2 driver type
RS485 Single
Date/Time
Japan Standard
Time
EdCentra
DHCP
ENABLE
Setting
IP address
0.0.0.0
Subnet mask
0.0.0.0
Default gateway
0.0.0.0
Primary DNS Server
0.0.0.0
Secondary DNS Server
0.0.0.0
SNTP
ENABLE
SNTP Server
0.0.0.0
Time Sync with SNTP
DISABLE
MQTT Broker Address
192.168.0.100
Table 7 - User setting data list