USING THE E-42B 33
TO SHUT DOWN, RESTART, OR REBOOT FROM THE E-42B CONTROL PANEL
NOTE: Notify the network administrator before you remove the E-42B from the network.
1 Make sure that the E-42B is not receiving, processing, or printing any jobs.
If Printing appears on the control panel, the E-42B is processing. You must wait until the
system finishes and reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
2 If the logo screen is displayed, press the Menu button once to display the Functions menu.
3 Make a selection:
• To restart or reboot the E-42B, select Restart Server. A submenu displays allowing you to
select Restart Server, Reboot System, or Cancel.
• To shut down the E-42B immediately, select Shut Down System.
NOTE: Use the reset button on the front of the E-42B only if the system is unresponsive to
keyboard or mouse actions.
Allow the system to shut down and power off or restart.
If you selected Restart Server, you may need to wait 1 minute or more for the server software
to restart.
Before accessing internal components following a shutdown, make sure that all cables are
disconnected from the back of the E-42B.
Server name
This logo screen indicates that the E-42B is Idle.
Menu button
Eject CD/DVD
IP Address
Restart Server
Shut Down System
Server name
Restart Server
Reboot System
Cancel
Server Name
Immediately shuts down
the E-42B
Displays a submenu
To Next Page
Loading...
Need help?
General
