USING THE E-42B 34
TO SHUT DOWN, RESTART, OR REBOOT FROM THE COPIER/PRINTER TOUCH PANEL
NOTE: Notify the network administrator before you remove the E-42B from the network.
1 Make sure that the E-42B is not receiving, processing, or printing any jobs.
If Printing appears on the control panel, the E-42B is processing. You must wait until the
system finishes and reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
2 Press the “fierydriven®” button on the copier/printer and make sure that Idle appears on the
copier/printer touch panel (see page 27).
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
NOTE: Notify the network administrator before you remove the E-42B from the network.
3 Press the Fiery tab.
4Press Restart Fiery.
5 At the next screen, select one of the following options:
• Restart Fiery Service (soft reset)—Resets the E-42B server software but does not reboot
the entire system. Network access to the E-42B is temporarily interrupted and all currently
processing jobs are aborted and may be lost. If you choose this option, you may need to
wait 1 minute or more for the server software to reset.
•
Reboot System (hard reset)—Shuts down all E-42B activity properly and then reboots.
Network access to the E-42B is temporarily interrupted and all currently processing jobs
are aborted and may be lost.
•
Shut Down—Shuts down all E-42B server software and powers off the system. You should
always select this option when you want to power off the system. Network access to the
E-42B is terminated and all currently processing jobs are aborted and may be lost.
NOTE: Use the reset button on the front of the E-42B only if the system is unresponsive to
keyboard or mouse actions.
6Press OK.
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-42B.
To Next Page
Loading...
Need help?
General
