EIP 545A - Page 11

I BAND 1
RANGE-^^^^
10 Hz to 100 MHz
25
mV rms
1 Mn120pF
CONNECTOR BNC(female)
MAX. INPUT LEVEL 120Vrms '
DAMAGE LEVEL 150 V rms
(Above 1 KHz max.
down to 3.0 V rms.
)
RANGE
10 MHz to 1
GHz
SENSITIVITY -20 dBm
DYNAMIC RANGE 30 dB
IMPEDANCE
50R Nominal
CONNECTOR BNC
(female)
MAX. INPUT LEVEL - +10 dBm
DAMAGE LEVEL
+27
dBm
ACQUISITION TIME
< 50 msec
RANGE
1
GHz to 18 GHz (26.5 GHz for model 548A)
I
SENSITIVITY
-30
dBm: 1 GHz-12.4 GHz
-25 dBm : 12.4 GHz- 18 GHz
-20 dBm : 18 GHz-22 GHz
-15 dBm : 22 GHz - 26.5 GHz
1 GHz to 12.4 GHz, 37 dB
18
GHz to 22 GHz, 27 dB
12.4
GHz to 18 GHz, 32 dB
22
GHz to 26.5 GHz, 22 dB
5052 Nominal
CONNECTOR
Model 545A
- Precision type N, (female)
Model 548A
- APC - 3.5 (female)
+-
5 Watts (+37 dam)
1 ACQUISITION TIME - 250 msec lnde~endent of freauencv
--
. .
AUTO AMPLITUDE (Automatic amplitude discrimination of two
DISCRIMINATION frequencies) 10 dB
FM MODULATION
20 MHz P-P up to 10 MHz rate
VSWR
< 2.5:l typical
FREQUENCY
LIMIT
Keyboard control of desired limits (standard). Counter
will measure largest signal within programmed limits.
Signal outside operating band must be separated by at
least 100 MHz from either limit. For signals more than
10 dB above desired signal, separation is typically
200
MC17
FREQUENCY 10 MHz TCXO
AGING RATE
<I 3 x 10-~Iper month
SHORT TERM
< ( 1 x 10-glrms for one second averaging time.
TEMPERATURE
<I2 x 10-61 O"to+50°C
LINE VARIATION
<I 1 x 107 1 "O%chanae.
WARM UP TIME NONE
OUTPUT FREQUENCY 10 MHz, square-wave, 1 V p-p
mlnimum into 50 ohms.
EXT.
TIME BASE
Requires 10 MHz, 1 V
p-p minimim into 300 ohms.
Scans by ArtekMedia © 2007