E L A N H O M E S Y S T E M S S1616A AMPLIFIER MODE
© ELAN Home Systems 2012 | All rights reserved.
Utility Sub-Menu (Continued)
Power Saving Menu
The Power Saving mode uses Music Sense detection to determine if audio signals are present. If
signals are not present, the enabled amplifier channels power OFF. When a source signal is
detected the channels will power ON.
The factory default is ALL ENABLED.
When ALL ENABLED is selected, any channel will shut itself off after 5 minutes with no audio
detected.
ALL ENABLED examples:
If a zone is turned off on an ELAN A/V Controller and the A/V Controller's triggers are not
connected, the S1616A's channels will turn off after 5 minutes of not detecting audio.
If a zone is muted on the ELAN A/V Controller, the S1616A's channels will turn off after 5 minutes
of not detecting audio.
The S1616A audio may drop out in ALL ENABLED mode if the audio being sent to it is at an
extremely low level for five minutes.
(See Trigger information on pages 39-41.)
Once you have selected the Utility sub-menu by cycling through the MAIN Menu options using
the MENU button, use the CHANNEL button to select the POWER SAVING menu. Use the UP
and DOWN arrow buttons to select between All Enabled and All Disabled.
Figure 2-21
Power Saving Menu
To Next Page
