Aquastorm 200
17
17
Start-Up and Operation 3-17
Blower #1 On/Off Control
Press Blower #1 Control to activate Blower #1.
The green LED illuminates when the
blower is on.
Press the control again to deactivate Blower #1.
The green LED turns off when Blower
#1 is off.
Blower #2 On/Off Control
Press Blower #2 Control to activate Blower #2.
The green LED illuminates when the
blower is on.
Press the control again to deactivate Blower #2.
The green LED turns off when Blower
#2 is off.
Blower #3 On/Off Control
Press Blower #3 Control to activate Blower #3.
The green LED illuminates when the
blower is on.
Press the control again to deactivate Blower #3.
The green LED turns off when Blower
#3 is off.
Blower #4 On/Off Control
Press Blower #4 Control to activate Blower #4.
The green LED illuminates when the
blower is on.
Press the control again to deactivate Blower #4.
The green LED turns off when Blower
#4 is off.
Radiant Heater
On/Off Control
Press the Radiant Heater On/Off Control to
activate the optional radiant oven in Dryer #2
(and optional Dryer #4 if configured).
The green LED on the Radiant Heater
On/ Off Control illuminates to indicate
it is activated.
An asterik appears on the LCD in front
of RADIANT HEATER when the radiant
heaters are on. The asterik is not visible
when the heaters are off.
The radiant heaters will not heat up or reach
temperature until a temperature set point has
been set via the LCD operator interface.
Press the Radiant Heater On/ Off Control again
to turn off the optional radiant oven in Dryer
#2 (and optional Dryer #4 if configured).
The green LED on the Radiant Heater
On/ Off Control turns off to indicate the
heaters are off.
To Next Page
Loading...