Aquastorm 200
37
37
Start-Up and Operation 3-37
2.6 RESISTIVITY MONITOR
The Aquastorm 200 may be configured with an
optional Resistivity Monitor, whereby resistivity
levels in the incoming final rinse plumbing are
displayed on the custom control panel's LCD.
Resistivity levels from 0 - 20 Meg Ohms are
monitored continuously via a resistivity probe in
line with the incoming final rinse plumbing.
For calibration of the Resistivity Monitor refer
to the Maintenance Section of this manual.
Resistivity
Probe
Resistivity Monitor
To Next Page
Loading...