Electrovert Aquastrom 200 - System Clock and Date Setup

28#
3-28 Start-Up and Operation
Aquastorm 200
1.5 SYSTEM CLOCK AND
DATE SETUP
Perform the procedure that follows to make
changes to the system clock and date.
NOTE The internal clock is a 24 hour
clock.
1 To configure the system Clock and Date,
press the MENU key on the LCD interface
keypad to access the Configuration
Screen.
2 Press the Page Down key located on the
LCD interface keypad twice to view the
third (3rd) page of the Configuration
Screen.
3 Press the Down arrow key on the LCD
interface keypad until the underscore
cursor is in line with
SYS_CLOCK
SET.
4 Press the ENTER key on the LCD
interface keypad to access the DATE/
CLOCK utility.
5 Follow the instructions on the LCD.
When ENTER is pressed the underscore
cursor goes to the first character of the
present date displayed.
6 Use the number keys to enter the correct
DATE and TIME, then press ENTER on
the LCD interface keypad to accept the
changes; press MENU to exit once the
changes have been saved.
08-26-1996 08:12:04
PRESS ENTER TO SET
PRESS MENU TO EXIT