14.4 fitting the large decorative trim - with remote motion sensor
1. Push the controller into the rear of the decorative trim until the controller locks securely into place:
The rear cover of the controller must be removed to access the RJ45 connection port.
2. Connect the motion sensor cable - RJ45 connector - to the rear of the controller:
The motion sensor cable is a short length, please take care not damage the motion sensor housingwhile
fitting.
3. Fit the controller andmake the electrical connections.
14.5 fitting the large decorative trim - without motion sensor
1. Push the controller into the rear of the decorative trim until the controller locks securely into place:
ems25+ and ems25advanced / General Use
87 of 89
To Next Page
Loading...
