Elstat ems25advanced - How to Run the Test Routine (Tst)

See "differential (dIF)" on page 70
See "fan cycle on (FCO)" on
page 72
See "calibration 1 (CA1)" on page
68
See "fan cycle off (FCF)" on
page 72
See "saving set point (SSP)" on
page 76
See "display stability (d2)"
on page 69
See "saving differential (Sd)" on
page 75
See "buzzer enable (b0)" on
page 68
See "freeze-up protection (dtt)"
on page 72
See "buzzer duration (b1)"
on page 68
See "fan set point (FSP)" on page
73
See "alarm delay (Ad)" on
page 66
See "condenser high tem-
perature (Ht)" on page 73
See "activity frequency (AF)"
on page 67
See "defrost termination tem-
perature (dtd)" on page 71
See "motion sensor enable
(Sn)" on page 75
See "compressor rest time (rt)"
on page 75
See "saving temperature
disable (PEr)" on page 74
See "delay to saving (dS)" on page
71
See "learning period (LP)"
on page 74
See "lights delay (Ld)" on page 74
See "display (dIS)" on page
71
See "saving restart period (Sr)" on
page 76
See "marketing mode (Ar)"
on page 67
See "refrigeration system failure
(Ct)" on page 69
7.7 how to run the test routine (tst)
The test routine tests the following:
l all load relays
l analogue inputs (temperature sensors and door switch)
ems25+ and ems25advanced / General Use
40 of 89