Elstat ems25advanced - How to View the Last Three Alarms (Flt); How to View Statistics

3.
Ensure that PS is displayed.
4.
Press down to scroll down to the Hr menu.
5. Re-enter the button sequence of the menu entry password.
6. Ensure that the ems controller resets.
After a reset, the ems controller starts the power-up sequence.
7.9 how to view the last three alarms (FLt)
It is possible to view the last alarms and understand problems that have occurred with the ems controller.
View the last three alarm conditions as follows:
1.
Press and hold the set button until PAS is displayed.
2. Enter the button sequence of the menu entry password.
3.
Ensure that PS is displayed.
4.
Press down to scroll down to FLt.
5. Press the set button.
6. The last three faults, or alarms, to occur are displayed.
For example:
a condenser high temperature alarm has occurred
a refrigeration system failure alarm has occurred
a door open alarm has occurred
Please note:
l The alarms may have been cleared, or cancelled, by the retail outlet operators.
ems25+ and ems25advanced / General Use
43 of 89