step image
2 Release the set button when PAS appears
3 Press the set button four times (x4)
4 Press the up button once (x1)
5 Press the down button twice (x2)
6 Press the defrost / teach button twice (x2)
7.4 how to access the menu
Access the ems controller menu as follows:
1.
Press and hold the set button until PAS is displayed.
2. Enter the button sequence of the password.
3.
Ensure that PS is displayed.
The table below describes the ems controller menus. Use the down button to scroll through the menu.
menu display description
parameter
list
Displays the parameters and the parameter values.
test routine
Enters the test routine that tests the relays, temperature sensors, door switch, and
motion sensor.
faults
Displays the last three faults (alarms).
See "how to view the last three alarms (FLt)" on page 43
half reset Clears the self-learning matrix. See "how to perform a half reset (Hr)" on page 42
ems25+ and ems25advanced / General Use
37 of 89
To Next Page
Loading...
