ELTEX MES3108 - Page 168

168 MES3000 Ethernet switch series
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.195—Global configuration mode commands
Command
Value
Action
ip sla responder udp_jitter port
port: (1..65535)
Enable IP SLA Resonder and set the listening port for UDP Jitter
operation.
- port - port number.
no ip sla responder udp_jitter
Disable IP SLA Responder.
IP SLA operation creation mode commands
Command line request in IP SLA operation creation mode appears as follows:
console(config-ip-sla)#
Table 5.196 —IP SLA operation creation mode commands
Command
Value/Default value
Action
udp-jitter target_address
target_port [source-address
source_address] [source-port
source_port] [num-packets
num_packets] [interval
interval]
target_port: (1..65535);
source_port:
(1..65535)/61040;
num_packets:
(1..1000)/10 packets;
interval: (1..60000)/20
ms
Create UDP Jitter operation
- target_address - IPv4 address for receiving UDP packets.
- target_port - destination UDP port; should match UDP port
configured on the responder.
- source_address - IPv4 address used for placement into UDP
packet header.
- num_packets - number of UDP packets in each sequence.
- interval - time interval between packets in a sequence.
You can define ‘udp-jitter’ command parameters only at the time of operation creation; you
will not be able to edit them later. To define other parameters, remove the existing operation
and create a new one.
ICMP Echo operation configuration mode commands
Command line request in UDP Jitter operation configuration mode appears as follows:
console(config-ip-sla-udp-jitter)#
Table 5.197 —ICMP Echo operation configuration mode commands
Command
Value/Default value
Action
frequency secs
secs: (1..128)/60
seconds
Set the frequency of UDP Jitter operation execution in seconds.
- secs – frequency of UDP Jitter operation execution.
no frequency
Set the default frequency.
timeout msec
msec:
(1..3600000)/1000 ms
Set UDP Jitter operation timeout in milliseconds.
- msecs – timeout of UDP Jitter operation.
no timeout
Set the default timeout.
request-data-size bytes
bytes: (20..1432)/30
bytes
Set the number of bytes transmitted in UDP packet as a data
(payload).
- bytes – number of bytes.
no request-data-size
Set the default number of bytes.
tos byte
byte: (1..255)/0
Set the value of Type of Service byte, transmitted in Differentiated
Services Field of the IP packet header.
- byte – value of Type of Service byte in Differentiated Services
Field.
no tos
Set the default Type of Service byte value.
tag string
string: (1..63)
characters
Define the text tag for operation.
- string – a text tag.
no tag
Remove the text tag.