ELTEX MES3108 - Commands for Configuration of Password Parameters

46 MES3000 Ethernet switch series
no hostname
characters/-
Set the default network device name.
stack master unit unit
unit: (1..2)/no master
device
Assign the master device in a stack.
This command is available in the stackable mode only.
no stack master unit
Set the default value.
service cpu-utilization
-/enabled
Allow the device to perform software-based measurement of the
switch CPU load level.
no service cpu-utilization
Deny the device to perform software-based measurement of the
switch CPU load level.
service cpu-input-rate
-/disabled
Allow the device to perform software-based speed measurement
of inbound frames, processed by the switch CPU.
no service cpu-input-rate
Deny the device to perform software-based speed measurement
of inbound frames, processed by the switch CPU.
service cpu-rate-limits traffic
limit pps
traffic: (http, telnet,
ssh, snmp, ip, link-local,
arp-switch-mode,
arpinspection,
stpbpdu, other-bpdu,
dhcp-snooping,
dhcpv6snooping,
igmpsnooping,
mldsnooping, sflow,
log-deny-aces, ptp,
other);
pps: (8..1024)
Set the restrictions on the speed of inbound frames for the
selected type of traffic.
- pps—packets per second.
service tasks-utilization
-/disabled
Allow the device to perform software-based measurement of the
switch CPU load level for each system process.
no service tasks-utilization
Deny the device to perform software-based measurement of the
switch CPU load level for each system process.
system resources routing
routes hosts interfaces
routes: (20..11136)
hosts:(20..2800)
interfaces: (2..1024)
Set the size of the routing table.
- routes—maximum quantity of remote networks
- hosts—maximum quantity of connected hosts
- interfaces—maximum quantity of IP interfaces
reset-button {enable |
disable | reset-only}
-/enable
F button settings
- enable — reboot the device by pressing the F button less than 10
seconds, reset the device to default by pushing the F button more
than 10 seconds
-disable — F button is off
- reset-only — only reboot
5.5 Commands for configuration of password parameters
This set of commands is designed for minimum password complexity and duration configuration.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.17 —System management commands in global configuration mode
Command
Value/Default value
Action
passwords aging age
age: (0..365)/0 days
Define password duration. When this period expires, you will be
asked to change the password. Zero value '0' means that the
password duration is not set.
no password aging
Restore the default value.
passwords complexity enable
-/disabled
Enable password format restriction.
passwords complexity
minclasses value
value: (0..4)/3
Enable the restriction for the minimum quantity of character
classes (lowercase, uppercase, numbers, symbols).