ELTEX MES3108 - 4.3 Startup menu

30 MES3000 Ethernet switch series
Dram first block size is : 229376K bytes Dram first PTR is : 0x1C00000 Dram
second block size is : 4096K bytes Dram second PTR is : 0xFC00000 Flash size is:
16M
05-Jun-2011 16:14:09 %CDB-I-LOADCONFIG: Loading running configuration.
05-Jun-2011 16:14:09 %CDB-I-LOADCONFIG: Loading startup configuration.
Device configuration:
Slot 1 - 28 ports
Device 0: GT_98DX4122 (BobCat)
------------------------------------
-- Unit Standalone --
------------------------------------
Tapi Version: v1.9.3.2
Core Version: v1.9.3.2
If the switch startup was successful, you will see CLI interface prompt.
console>
To quickly get help with available commands, use key combination SHIFT+?.
4.3 Startup menu
To enter the startup menu, connect to the device via RS-232 interface, reboot the device and press
ESC or ENTER keys in 2 seconds after POST procedure completion.
Boot1 Checksum Test...............................PASS
Boot2 Checksum Test...............................PASS
Flash Image Validation Test.......................PASS
BOOT Software Version 0.0.0.3 Built 17-Aug-2010 23:18:59
Networking device with CPU based on arm926ejs core. 256 MByte SDRAM.
I-Cache 16 KB. D-Cache 16 KB. L2 Cache 256 KB. Cache Enabled.
MAC Address : a8:f9:4b:a3:a4:a6.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Startup menu appearance:
Startup Menu
[1] Download Software
[2] Erase Flash File
[3] Password Recovery Procedure
[4] Set Terminal Baud-Rate
[5] Stack menu
[6] Back
Enter your choice or press 'ESC' to exit:
Table 4.1 — Startup menu interface functions
Function
Description
Download Software
Download new version of the switch firmware using XMODEM
Erase Flash File
Wipe the data from Flash
Password Recovery
Procedure
Reset authentication settings
Set Terminal Baud-Rate
Set terminal mode operation speed