MES3000 Ethernet switch series 91
Show ARP table contents:
сonsole# show arp
VLAN Interface IP address HW address status
--------------------- --------------- ------------------- ---------------
vlan 1 gi0/12 192.168.25.1 02:00:2a:00:04:95 dynamic
5.15.3 GVRP protocol configuration
GARP VLAN Registration Protocol (GVRP). This protocol allows to distribute VLAN identifiers in the
network. The basic function of GVRP is to discover information on VLAN networks, that are missing from
the switch database, upon receiving GVRP messages. Switch adds received information on missing VLANs
to its database.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.77 —Global configuration mode commands
Enable GVRP protocol for the switch.
Disable GVRP protocol for the switch.
Ethernet interface configuration mode commands (interface range), port group interface
Command line request in Ethernet interface, port group interface configuration mode appears as
follows:
console# configure
console(config)# interface {gigabitethernet gi_port| tengigabitethernet
te_port|port-channel group}
console(config-if)#
Table 5.78 —Ethernet interface configuration mode commands, interface group
Enable GVRP utilization for configured interface.
Disable GVRP utilization for configured interface.
garp timer {join | leave |
leaveall} timer_value
timer_value:
(10..2147483640) ms
Default values:
join: 200 ms
leave: 600 ms
leaveall: 10000 ms
Set the GARP timer value (for time description, see Table 5.79).
timer_value—timer value (must be divisible by 10).
gvrp vlan-creation-forbid
Disable dynamic VLAN modification or creation for configured
interface.
no gvrp vlan-creation-forbid
Enable dynamic VLAN modification or creation for configured
interface.
Be default, VLAN
creation and
registration is enabled
for the interface.
Deregister all VLANs and disable the creation or registration of
new VLANs on the current interface.
no gvrp registration-forbid
Restore the default value.