MES3000 Ethernet switch series 227
6 SERVICE MENU, CHANGE OF SOFTWARE
6.1 Startup Menu
Startup menu is used for performance of specific processes, s.a.: update of software, removal of
content of flash memory, restoration of password, diagnostics, setting the terminal operation rate, work
with parameters of device stack.
To enter Startup menu it is required to interrupt loading by pressing <Esc> or<Enter> keys within
first two seconds after automatic loading message appears (when POST procedure is finished).
Startup Menu
[1] Download Software
[2] Erase Flash File
[3] Password Recovery Procedure
[4] Set Terminal Baud-Rate
[5] Stack menu
[6] Back
Enter your choice or press 'ESC' to exit:
To exit the menu and load the device press <6> or <esc> key.
If within 15 seconds (default value) no menu option has been selected then loading of the
device will continue. Time delay can be increased with help of console commands
Table 6.1- Description of Startup menu
Download Software
Download Software
X-Modem protocol is used for loading the software. When pressing <1> following message will
be displayed in console:
Downloading code using XMODEM.
Now, when device is ready to receive the file, it is required to transfer it with help of X-Modem
protocol. After the file is received the device would restart automatically.
Erase Flash File
Erase Flash File
This procedure is used for removal of device configuration. In order to remove the file press
<2>, warning (confirm by pressing <y>) will appear:
Enter name of configuration file:
Write Flash file name (Up to 8 characters, Enter for none.):CDB
File CDB (if present) will be erased after system initialization.
==== Press Enter To Continue ====
To return to the menu Startup press <Enter>.
Password Recovery
Procedure
Password Recovery
Procedure
This procedure is used to recover lost password, it allows to connect to the device without
password.
To recover password press <3>, during next connecting to device the password will be ignored.
Current password will be ignored!
To return to Startup menu, press <Enter> key.
==== Press Enter To Continue ====
This procedure is used for setting speed of terminal operation (115200 baud by default).
In order to set new rate of terminal operation press <5> and enter the value:
Set new device Baud rate: 115200
To Next Page
Loading...
