ELTEX MES3108 - Multicast Traffic Restriction Functions

MES3000 Ethernet switch series 129
ipv6 mld
lastmemberquerycount
count
count: (1..7)
Define the quantity of MLD queries sent before the switch will
determine the absence of IPv6 multicast participants.
no pv6 mld
lastmemberquery-count
Restore the default value.
ipv6 mld
lastmemberqueryinterval
interval
interval:
(100..25500)/1000 ms
Define the maximum response delay of the last group participant,
that will be used for maximum response delay code calculation
(Max Response Code).
no ipv6 mld
lastmemberquery-interval
Restore the default value.
ipv6 mld query-interval value
value: (30..18000)/125
seconds
Define the sending interval for basic MLD requests.
no ipv6 mld query-interval
Restore the default value.
ipv6 mld
querymaxresponsetime
value
value: (5..20)/10
seconds
Define the maximum response delay that will be used for
maximum response delay code calculation.
no ipv6 mld
querymaxresponse-time
Restore the default value.
ipv6 mld robustness value
value: (1..7)
Specify the robustness ratio. If the data loss is discovered for the
channel, robustness ratio should be increased.
no ipv6 mld robustness
Restore the default value.
Ethernet interface configuration mode commands (interface range), port group interface,
VLAN interface
Command line request in Ethernet interface, port group, and VLAN interface configuration mode
appears as follows:
console(config-if)#
Table 5.134 —Ethernet interface configuration mode commands, interface group
Command
Value/Default value
Description
ipv6 mld join-group
ipv6_multicast_address
-
Perform the MLD-report message transmission for joining
ipv6_address group from the current port.
- ipv6_multicast_address—IPv6 multicast address
no ipv6 mld join-group
ipv6_multicast_address
Remove transmition of MLD report messages for joining
ipv6_address group from the current port.
ipv6 mld version version
version: (1..2)/2
Define the protocol version operating on the current interface.
no ipv6 mld version
Restore the default value.
Table 5.135 —EXEC mode commands
Command
Value
Action
show ipv6 mld snooping
groups [vlan vlan_id] [address
ipv6_multicast_address]
[source ipv6_address]
vlan_id: (1..4094)
Show information on registered groups according to filter
parameters defined in the command.
- ipv6_multicast_address—IPv6 multicast address
- ipv6_address—source IPv6 address
show ipv6 mld snooping
interface vlan_id
vlan_id: (1..4094)
Show information on MLD Snooping configuration for the current
VLAN.
show ipv6 mld snooping
mrouter [interface vlan_id]
vlan_id: (1..4094)
Show information on mrouter ports.
5.17.4 Multicast traffic restriction functions
Multicast traffic restriction functions allow to easily configure viewing restrictions for the specific
multicast groups.
Global configuration mode commands
Command line request in global configuration mode appears as follows: