230 MES3000 Ethernet switch series
console# show bootvar
Image Filename Version Date Status
----- --------- --------- --------------------- -----------
1 image-1 2.5.44[0b70e656] 24-Nov-2015 17:28:25 Active*
2 image-2 2.1.6 05-Jun-2011 16:14:03 Active
Reboot the switch by command reload.
console# reload
This command will reset the whole system and disconnect your current
session. Do you want to continue (y/n) [n]?
Confirm reboot by entering <y>
6.2.2 Update of loading file of the device (initial loader)
Initial loader is launched just after device power switch on. With help of loading file procedure of
"system testing during switch on" (POST), unpacking and launch of system software file are performed.
When updating, the new file of initial loader is saved in flash memory instead of old one.
To view current version of loading file operating on the device, enter command show version:
console# show version
SW version 2.5.44[0b70e656] ( date 24-Nov-2015 time 17:28:25 )
Boot version 0.0.1.2 ( date 12-Dec-2012 time 19:10:41 )
HW version 02.07
CPLD version 03
Software update procedure:
1. With help of command copy copy new loading file to the device. Command format:
copy tftp://tftp_ip_address/[directory/]filename boot
Example:
console# copy tftp://192.168.16.34/332448-10018.rfb boot
Erasing file..done.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Copy: 2739187 bytes copied in 00:01:18 [hh:mm:ss]
Exclamation mark means that copying is in progress. Each exclamation mark corresponds to
successful transfer of 10 packages with 512 bytes of information each. Point means that
during copying time-out of packages from TFTP server occurred. Several points in line can
mean that error occurred during copying.
To Next Page
Loading...
Need help?
General
