MES3000 Ethernet switch series 17
Table 2.8 —Additional device functions
MES3000 network switches are equipped with the hardware and software tools,
that allow them to perform functions of a virtual cable tester—VCT. The tester
allows to determine the condition of the copper-wire communication cable
(ok/break/short-circuit) and to measure the length of the fault-free cable. Test
results are compiled into the report.
Optical transceiver
diagnostics
The device allows to test the optical transceiver. During testing, the device
monitors the current, power voltage and transceiver temperature. To be
implemented, these features should be supported by the transceiver.
This mechanism allows the switch to reduce the power consumption by disabling
inactive electric ports.
Active monitoring technology used for measuring network performance and data
transmission quality. Supported operations: ICMP Echo, UDP Jitter.
2.3 Main specifications
Table 2.9 lists main specifications of the switch.
Table 2.9 —Main specifications
8x10/100/1000Base-T
2x(10GBase-X (SFP+)/1000Base-X (SFP)
4x1000 Base-X (SFP)
4xCombo (10/100/1000Base-T/1000Base-X)
2x(10G Base-X (SFP+)/1000Base-X (SFP))
16x10/100/1000Base-T
2x(10GBase-X (SFP+)/1000Base-X (SFP)
12x1000 Base-X (SFP)
4xCombo (10/100/1000Base-T/1000Base-X)
2x(10G Base-X (SFP+)/1000Base-X (SFP))
24x10/100/1000Base-T
4x(10GBase-X (SFP+)/1000Base-X (SFP))
20x1000 Base-X (SFP)
4xCombo (10/100/1000Base-T/1000Base-X)
4x(10G Base-X (SFP+)/1000Base-X (SFP))
24x10/100/1000Base-T,
2x(10GBase-X (SFP+)/1000Base-X (SFP)),
2x(10GBase-LR/ER/ZR (XFP))
20x1000 Base-X(SFP),
4 Combo (10/100/1000 Base-T/1000 Base-X),
2 (10GBase-X(SFP+)/1000Base-X (SFP),
2x(10GBase-LR/ER/ZR (XFP))
Full-duplex/Half-duplex mode
Full-duplex/half-duplex mode for electric ports, full-duplex mode for
optical ports