MES3000 Ethernet switch series 41
Table 5.6 —Global configuration mode commands
Show strings with first characters corresponding to the pattern
template
Display all strings that contain the pattern.
Display all strings that doesn't contain the pattern.
5.3 Macrocommand configuration
This function allows to create the unified sets of commands—macros that can be used later for
configuration purposes.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.7 —Global configuration mode commands
Create a new command set; if the set with such name exists, it will
be overwritten. Commands are entered one line at a time. Finish
the macro with '@' character. Maximum macro length—510
characters.
Delete the selected macro.
Apply the selected macro.
Validate the selected macro.
macro global description word
word: (1..160)
characters
Create the global macro descriptor string.
no macro global description
Delete the descriptor string.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console>
Table 5.8 —EXEC mode commands
Apply the selected macro.
Validate the selected macro.
show parser macro
[description [interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group}] | name
macro_name]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24);
macro_name: (1..32)
characters
Show parameters of macros configured on the device.
Interface configuration mode commands
Command line request in interface configuration mode appears as follows:
console(config-if)#