ELTEX MES3108 - File Operations; Command Parameters Description

MES3000 Ethernet switch series 47
no passwords complexity
minclasses
Restore the default value.
passwords complexity
minlength value
value: (0..64)/8
Enable minimum password length restriction.
no passwords complexity
minlength
Restore the default value.
passwords complexity
norepeat number
number: (0 ..16)/3
Enable the restriction for the minimum quantity of identical
consecutive characters in a new password.
no password complexity
norepeat
Restore the default value.
passwords complexity
notcurrent
-/enabled
Deny to use the old password, when the password is changed.
no passwords complexity
notcurrent
Allow to use the old password, when the password is changed.
passwords complexity
notusername
-/enabled
Deny to use username as a password.
no passwords complexity
notusername
Allow to use username as a password.
Table 5.18 —System management commands in Privileged EXEC mode
Command
Value/Default value
Action
show passwords configuration
-
Show information on password restrictions.
5.6 File operations
5.6.1 Command parameters description
URL addresses—resource locators—are used as command parameters in file operations. For
description of keywords used in operations, see Table 5.19.
Table 5.19 —Keyword list and description
Keyword
Description
flash://
Source or destination address for non-volatile memory. Non-volatile memory is used by
default, if URL address is defined without the prefix (prefixes: flash:, tftp:, scp:…).
running-config
Current configuration file.
startup-config
Initial configuration file.
image
If the source file—this image is active.
If the destination file—this image is inactive.
boot
Load file.
tftp://
Source or destination address for TFTP server.
Syntax: tftp://host/[directory] /filename.
host—IPv4 address or device network name;
directory—directory;
filename—file name.
scp://
Source or destination address for SSH server.
Syntax: scp://[username[:password]@]host/[directory/] filename
username—user name;
password—user password;
host—device IPv4 address of network name;
directory—directory;
filename—file name.
xmodem:
Source file address for X-modem protocol through the serial connection.
unit://member/startup-config
Configuration file, used during the device startup.
member—IP address or device network name in a stack.
unit://member/image
System firmware file on the device or on one of the stacked devices. To copy file from the
master device to other modules, use '*' symbol in the member element.
member—IP address or device network name in a stack.