ELTEX MES3108 - Page 92

92 MES3000 Ethernet switch series
Table 5.79 —GARP timer description
GARP timer
Value
Join Timer
Define the request transmission interval for adding VLAN into the group (value range
from 10 to 2147483640 ms, default value 200 ms).
Leave Timer
Define the amount of time the interface will wait before leaving the VLAN group (value
range from 10 to 2147483640 ms, default value 600 ms).
Leave timer value should be greater or equal to 3 x Join timer value.
LeaveAll Timer
Define the amount of time the interface will wait before sending LeaveAll request for
complete disconnection from VLAN group (value range from 10 to 2147483640 ms,
default value 10000 ms).
Leave timer value should be much greater than Leave timer value.
GARP timer values should be the same for all communicating devices. If timer values are
different, the switch will not be able to operate with GVRP protocol correctly.
Communication of untagged and tagged ports can be defined administratively by setting PVID
value for the untagged port.
Interface configured in the access port mode will not be able to work with GVRP protocol,
since it always belongs to only one VLAN group.
Privileged EXEC mode commands
Command line request in privileged EXEC mode appears as follows:
console#
Table 5.80 —Privileged EXEC mode commands
Command
Value
Action
clear gvrp statistics
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Clear collected GVRP statistics.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console>
Table 5.81 —EXEC mode commands
Command
Value
Action
show gvrp configuration
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
Show GVRP configuration for the selected interface or for all
interfaces.
show gvrp statistics
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
Show collected GVRP statistics for the selected interface or for
all interfaces.
show gvrp error-statistics
[gigabitethernet gi_port |
tengigabitethernet te_port |
port-channel group]
Show GVRP error statistics for the selected interface or for all
interfaces.