ELTEX MES3108 - Page 211

MES3000 Ethernet switch series 211
dp: (0–2)
All packets have dp=0 drop
priority by default.
dropped; the first packets to drop have priority 0, then 1, 2,
etc.).
- dscp-list—defines up to 8 DSCP values separated by spaces.
Valid for the qos advanced mode only.
no qos map dscp-dp
[dscp-list]
Sets the default values.
qos map dscp-cos dscp_list
to cos
dscp_list: (0..63);
cos: (0..7)
Fill in the table of repeated DSCP marking. Change DCSP value
on CoS
no qos map dscp-cos
[dscp_list]
Restore the default value
qos map cos-dscp cos to
dscp_list
dscp_list: (0..63);
cos: (0..7)
Fill CoS remarking table. Replace CoS values by DSCP values.
no qos map cos-dscp [cos]
Restore the default values
qos trust {cos | dscp}
-/cos
Sets the switch trusted mode in the QoS basic mode (CoS or
DSCP).
- cos—sets CoS classification of incoming packets. The default
CoS value is used for untagged packets.
- dscp—sets DSCP classification of incoming packets.
Valid for the qos basic mode only.
no qos trust
Sets the default values.
qos dscp-mutation
-
Enables the use of the table of DSCP changes for the set of
DSCP-trusted ports. The table of changes allows DSCP values
of IP packets to be rewritten with new values.
The table of DSCP changes can be used only for
incoming traffic of trusted ports.
Valid for the qos basic mode only.
no qos dscp-mutation
Disables the use of the DSCP changes.
qos map dscp-mutation
in-dscp to out-dscp
in-dscp: (0–63)
out-dscp: (0–63)
The table of changes is
empty by default, i. e. DSCP
values remain the same for
all incoming packets.
Fills in the table of repeated DSCP marking. Sets new DSCP
values for incoming packets with specified DSCPs.
- in-dscp—defines up to 8 DSCP values separated by spaces.
- out-dscp—defines up to 8 DSCP values separated by spaces.
Valid for the qos basic mode only.
no qos map dscp-mutation
[in-dscp]
-
Sets the default values.
rate-limit vlan_id rate
burst
vlan_id: (1– 4094)
rate: (3 – 57,982,058) kbps
burst: (3000– 19,173,960)
bytes / 128 kilobytes
Limits incoming traffic rate for the specified VLAN.
- vlan_id—VLAN number;
- rate—average traffic rate (CIR), kbps;
- burst—size of the burst threshold (rate limit) in bytes.
no rate-limit
Removes the incoming traffic rate limitation.
Commands of the Configuration Mode for the List of Traffic Classification Criteria
Command line request of the configuration mode for the list of traffic classification criteria appears
as follows:
console# configure
console(config)# class-map class-map-name [match-all|match-any]
console(config-cmap)#