ELTEX MES3108 - Page 213

MES3000 Ethernet switch series 213
vlan_id: (1..4094)
only to outgoing interfaces.
Valid for the qos advanced mode only.
no set
Deletes new values of IP packet.
police
committed_rate_kbps
committed_burst_byte
[exceed-action {drop |
policed-dscp-transmit }]
committed-rate: (3–
12,582,912) kbps
committed-burst: (3000–
19,173,960) bytes
Allows bandwidth limitation and at the same time guarantees
a certain data transfer rate.
The "marked bucket" algorithm is used for work with
bandwidth. The goal of the algorithm is to make a decision
whether to send or drop a packet. The algorithm parameters
are: the rate of token arrival to the "bucket" (CIR) and the
"bucket" size (CBS).
- committed_rate_kbps—average traffic rate, kbps. This rate is
guaranteed.
- committed_burst_byte —size of the burst threshold in bytes;
- drop—a packet will be drop if the "bucket" is full;
- policed-dscp-transmit—if the "bucket" is full, the DSCP value
will be overwritten.
Valid for the qos advanced mode only.
no police
Disables channel rate configuration.
police agregate
aggregate_policer_name
(1–32) characters
Assigns a configuration template to a classification rule that
allows bandwidth limitation and at the same time guarantees
a certain data transfer rate.
Valid for the qos advanced mode only.
no police agregate
aggregate_policer_name
Removes the channel rate configuration template from the
traffic classification rule.
Qos tail-drop profile configuration mode commands
Command line request in configuration mode for qos tail-drop profile appears as follows:
console# configure
console(config)# qos tail-drop profile profile_id
console(config-tdprofile)#
Table 5.258 - Qos tail-drop profile configuration mode commands
Command
Value/Default value
Action
port-limit limit
limit: (0..400)/64
Set packet separated pool value for a port
no port-limit
Restore the default value
queue queue_id [limit limit]
[without-sharing |
withsharing]
limit: (0..400)/64;
queue_id: (1..8)
Change queue parameters
- queue_id –queue number;
- limit –quantity of packets in queue;
- without-sharing –prohibits access to a common pool
- with-sharing –allows access to a common pool
no queue queue_id
Restore the default value
Commands for Interface Configuration of Ethernet Interface and a Group of Ports
Command line request in the interface configuration mode for Ethernet interface and a group of
ports appears as follows:
console(config-if)#