ELTEX MES3108 - Page 39

MES3000 Ethernet switch series 39
Table 5.1 —Basic commands available in EXEC mode
Command
Value/Default value
Action
enable [priv]
priv: (1..15)/15
Switch to the privileged mode (if the value is not defined—
privilege level 15).
login
-
Close the current session and switch the user.
exit
-
Close the active terminal session.
help
-
Get help on command line interface operations.
show history
-
Show the history of commands, entered during the current
terminal session.
show privilege
-
Show the privilege level of the current user.
terminal history
- enabled
Enable saving history of commands, entered during the current
terminal session.
no terminal history
Disable saving history of commands, entered during the current
terminal session.
terminal history size size
size: (10..216)/10
Change buffer size for history of commands, entered during the
current terminal session.
no terminal history size
Set the default value.
terminal datadump
-/disabled
Show command output without splitting to pages (string that used
to split help output into pages: 'More <space>, Quit: q, One line:
<return>').
no terminal datadump
Set the default value.
show banner [motd | login |
exec]
-
Displays banner configuration.
Privileged EXEC mode commands
Command line request appears as follows:
console#
Table 5.2 —Basic commands available in privileged EXEC mode
Command
Value/
Default value
Action
disable [priv]
priv: (1..15)/1
Return to the normal mode from the privileged mode (if the value
is not defined—privilege level 1).
configure[terminal]
-
Enter the configuration mode.
debug-mode
-
Enter the debug mode (this command is available to privileged
users only).
set system mode {acl-sqinq |
acl-sqinq-udb}
-/acl-sqinq
Set traffic filtering configuration mode.
- acl-sqinq – default mode;
- acl-sqinq-udb – enables use up to 13 user defined offsets (5 by
default); all SQinQ rules for ingress traffic use twice as much
resources.
After changing the mode startup configuration will be
erased and the device will reboot.
Commands available in all configuration modes
Command line request appears as follows:
console#
console(config)#
console(config-line)#
Table 5.3 —Basic commands available in all configuration modes
Command
Value/Default value
Action
exit
-
Exit from any configuration mode to the upper level in CLI
command hierarchy.