44 MES3000 Ethernet switch series
Privileged EXEC mode commands
Command line request in privileged EXEC mode appears as follows:
console#
Table 5.11 —System management commands in privileged EXEC mode
Use this command to restart the device.
- unit_id—number of device in a stack
reload in [minutes | hh:mm]
minutes: (1..999);
hh (0..23), mm (0..59).
Sets the time period for delayed device restart.
Show statistics on CPU load level.
Show statistics on the speed of inbound frames, processed by CPU.
show cpu input-rate detailed
Show statistics on the speed of inbound frames, processed by CPU,
for each traffic type.
Show restrictions on the speed of inbound frames, processed by
CPU.
Zero the CPU packet counter.
show system defaults
[{management | ipv6 | 802.1x |
port | fdb | multicast |
portmirroring |
spanningtree | vlan |
voicevlan | network-security |
dos-attacks | ip-addressing |
qos-acl}]
Show the device factory settings.
show system resources routing
Shows information on routing table resources utilization.
show system resources tcam
Show detailed information about using of TCAM (Ternary Content
Addressable Memory) resources.
Show information on traffic filtering configuration mode.
Example use of traceroute command:
console# traceroute eltex.com
Type Esc to abort.
Tracing the route to eltex.com (148.21.11.69)
1 gateway.eltex (192.168.1.101) 0 msec 0 msec 0 msec
2 eltexsrv (192.168.0.1) 0 msec 0 msec 0 msec
3 * * *
Table 5.12 —Description of 'traceroute' command execution results
Sequence number of the router in the path to the specified network node.
Network name for this router.
IP address of the router.
The time that the packet was sent to and returned from the router. Specified for each
packet transmission attempt.
Execution of traceroute command can lead to errors, see error description in the table.
To Next Page
Loading...
