ELTEX MES3108 - Page 71

MES3000 Ethernet switch series 71
Fig. 23 – Example of Private VLAN technology
Command line request in configuration mode for Ethernet, VLAN interface and port group interface
appears as follows:
console# configure
console(config)# interface {tengigabitethernet te_port | gigabitethernet
gi_port | port-channel group | range {…} | vlan vlan_id}
console(config-if)#
Table 5.41 - Ethernet interface configuration mode commands
Command
Value/Default value
Action
switchport mode mode
mode: (promiscuous,
host)
Define port operation mode in VLAN.
- mode – VLAN port mode
no switchport mode
Set the default value
switchport private-vlan
mapping primary_vlan [add |
remove secondary_vlan]
primary_vlan:
(1..4094);
secondary_vlan:
(1..4094)
Add (remove) primary and secondary VLAN on a promiscuous
interface.
It is possible to add no more than one primary VLAN on
promiscuous interface.
no switchport private-vlan
mapping
Remove primary and secondary VLAN
switchport private-vlan host-
association primary_vlan
secondary_vlan
primary_vlan: (1..4094)
secondary_vlan
(1..4094)
Add primary and secondary VLAN on host interface.
It is possible to add no more than one secondary VLAN
on one host interface.
no switchport private-vlan
host-association
Remove primary and secondary VLAN
Table 5.42 – VLAN interface configuration mode commands
Command
Value/Default value
Action
private-vlan {primary |
isolated | community}
-
Enable Private VLAN mechanism and set type of interface
no private-vlan
Disable Private VLAN.