ELTEX MES3108 - Page 84

84 MES3000 Ethernet switch series
in 64 lower bits of IPv6 address
- anycast—identifies that the specified address is the anycast
address. (up to 64 IPv6 interfaces) .
no ipv6 address
[ipv6_address/prefix_length]
[eui-64]
Remove IPv6 address from the interface.
ipv6 address autoconfig
By default, automatic
configuration is
enabled, addresses are
not defined.
Enable automatic IPv6 address configuration for the interface.
Addresses are configured depending on prefixes, that were
received in Router Advertisement messages.
no ipv6 address autoconfig
Restore the default value.
ipv6 address
ipv6_address/prefix_length
link-local
Default value for local
address: (FE80::EUI64)
Define local IPv6 interface address. High bits of the local IP
addresses in IPv6—FE80::
no ipv6 address
[ipv6_address/prefix-length
link-local]
Remove the local IPv6 address.
ipv6 nd dad attempts
attempts_number
attempts_number:
(0..600)/1
Specify the quantity of demand messages, sent via the interface to
the device, when IPv6 address duplication (collision) is detected.
ipv6 unreachables
-/enabled
Disable ICMPv6 'destination inaccessible' messages, when sending
packets to the specific interface.
no ipv6 unreachables
Restore the default value.
ipv6 mld version {1 | 2}
-/2
Define MLD protocol version for the interface.
no ipv6 mld version
Restore the default value.
ipv6 mld join-group
group_address
-
Define MLD messages for the specific group.
group-address—IPv6 address of a multicast group.
no ipv6 mld join-group
group_address
Disable reporting and remove IP address from a multicast group.
Privileged EXEC mode commands
Command line request in Privileged EXEC mode appears as follows:
console#
Table 5.63 —Privileged EXEC mode commands
Command
Value/Default value
Action
ipv6 set mtu { gigabitethernet
gi_port | tengigabitethernet
te_port | port-channel group }
{bytes | default}
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24)
bytes:
(1280..65535)/1500
Define MTU value for IPv6 packets.
show ipv6 neighbors {static |
dynamic} [ipv6-address
ipv6_address] [mac-address
mac_address] [gigabitethernet
gi_port | tengigabitethernet
te_port | port-channel group |
vlan vlan_id]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24);
vlan_id: (1..4094)
Show information on the neighbouring IPv6 devices, stored in
cache.
- static—show static records
- dynamic—show dynamic records
clear ipv6 neighbors
-
Clear cache, that contains the information on the neighbouring
devices operating via IPv6. Information on static records will
remain.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#