ELTEX MES3108 User Manual

86 MES3000 Ethernet switch series
2. Enter the tunnelling interface configuration mode.
tunnel isatap query-interval
seconds
seconds: (10..3600)/10
seconds
Set the period between DNS requests, sent for automatic
discovery of ISATAP router IP address.
no tunnel isatap query-interval
Restore the default value.
tunnel isatap
solicitationinterval seconds
seconds: (10..3600)/10
seconds
Set the transmission period for requests, that require confirmation
from ISATAP router (if there is no active router).
no tunnel isatap
solicitationinterval
Restore the default value.
tunnel isatap robustness
number
number: (1..20)/3
Define quantity of DNS-query and quantity of queries, transmitted
to ISATAP router during the lifetime of established connection.
Request periods are defined by the following equations:
- for DNS: (lifetime received in the DNS server reply)/(number+1)
- for requests to ISATAP router: (minimum lifetime received in the
ISATAP router reply)/(number+1)
no tunnel isatap robustness
Restore the default value.
Tunnelling mode commands
Command line request in tunnelling mode appears as follows:
console# configure
console(config)# interface tunnel 1
console (config-tunnel)#
Table 5.66 —Tunnelling mode commands
Command
Value/Default value
Action
tunnel mode ipv6ip isatap
-/default
Enable IPv6 tunnelling support through IPv4 with ISATAP.
IPv6 addressing and tunnelling support can coexist in the
same interface (e.g. Ethernet/VLAN). IPv6 addressing
and tunnelling selection will be based on the information on the
destination IP address.
no tunnel mode ipv6ip isatap
Disable IPv6 protocol tunnelling support.
tunnel isatap router
router_name
-/the domain name is
'isatap'
Define the name for IPv6 tunnel. Users with IPv4 addressing will
be able to access the device (tunnelling device) while performing
the standard DNS procedure.
no tunnel isatap router
Restore the default value.
tunnel source { auto |
ipaddress ipv4_address }
-/IP address is not
defined
The command assigns the local IP address to a tunnel, that will be
used as a source address for packet transmission.
- auto—IP address will be automatically assigned by the system
no tunnel source
Delete local tunnel IP address.
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#
Table 5.67 —EXEC mode commands
Command
Value/Default value
Action
show ipv6 tunnel
-
Show information on the tunnel settings.
Example execution of commands
Enable tunnelling interface, define the tunnel domain name ABCD, define the local IP address
192.168.16.88.
console# configure
console(config)# interface tunnel 1
console(config-tunnel)# tunnel mode ipv6ip isatap
console(config-tunnel)# tunnel isatap router ABCD

ELTEX MES3108 Specifications

General

Brand	ELTEX
Model	MES3108
Category	Switch
Language	English