Elvaco CMeX50 - Page 53

CMeX50 Users Manual English
CMeX50 Users Manual English
page | 53 (89)
2017-10-13
Document id: 1090055 Version 1.5
79-86
0x02 0x7C 0x03 0x73 0x69
0x77 0xnn 0xnn
Continued installation time, 0xnnnn minutes.
(0x73 0x69 0x77 = 'wis' backwards, wireless
installation something...)
87-93
0x01 0x7C 0x03 0x6D 0x69
0x77 0xnn
0xnn = Wireless installation mode:
0x00 = Only SND-IR-telegram can install meters.
0x01 = All allowed telegram types can install
meters.
(0x6D 0x69 0x77 = 'wim', wireless installation
mode)
94-101
0x02 0x7C 0x03 0x65 0x67
0x61 0xnn 0xnn
0xnnnn = Time limit for wireless telegram in
minutes. Allowed interval is 0 .. 9999 minutes.
A virtual M-Bus slave will stop answering on wired
M-Bus if the latest stored telegram from the
corresponding wireless slave is older than this
value.
(0x65 0x67 0x61 = 'age' backwards)
102-111
0x04 0x7C 0x03 0x66 0x69
0x77 0xnn 0xnn 0xgg 0xgg
0xnnnn = Installation filter for manufacturer code:
0xFFFF = The filter is off. Meters from all
manufacturers can be installed.
Other values than 0xFFFF = only meters with the
specific manufacturer code can be installed.
0xgggg = Installation filter for DEV (meter type):
0xFFFF = The filter is off. All meter types can be
installed.
0x0000..0x00FF = Only the selected meter type can
be installed (DEV = 0x00..0xFF).
(0x66 0x69 0x77 = 'wif' backwards, wireless
installation filter)
112-118
0x01 0x7C 0x03 0x69 0x63
0x77 0xnn
0xnn = Setup for continuous installation mode:
0x00 = Only time limit installation
0x01 = Continuous mode is activated
( 0x69 0x63 0x77 = 'wci' backwards, wireless
continuous installation)
119-125
0x01 0x7C 0x03 0x6F 0x6D
0x74 0xnn
0xnn = Packing method or telegram:
0x00 = Automatic, wireless telegrams are repacked
to simulate virtual wired M-Bus slaves if possible.
At decryption error, wireless telegrams without
header, unknown CI-code, etc, the telegram will
automatically be placed untouched in a data
container.
0x01 = All wireless telegrams are placed in a data
container.
(0x6F 0x6D 0x74 = 'tmo' backwards, wire-mode (!))
126-132
0x01 0x7C 0x03 0x66 0x64
0x74 0xnn
0xnn = DIF/VIF-Mode:
0x00 = Auto
0x01 = Serial number
0x02 = Serial number, age
0x03 = Serial number, age, RSSI (signal strength)