180
Mode [ TP-UART / EIBnet IP Tunneling / EIBnet IP Tunneling(NAT mode) / EIBnet IP
Routing] KNX connection mode. LogicMachine5 has TPUART interface by default built-
in. Note! If there is no KNX TP connected to the device, it will automatically offer to
switch to KNXnet/IP mode.
ACK all group telegrams acknowledge receipt of telegram to all group communication
KNX address KNX physical address of the device
KNX IP features Use this device with KNX IP features e.g. for KNX device configuration
from ETS using LogicMachine
Multicast IP multicast IP address
Multicast TTL Time to live for multicast telegram in seconds
Maximum telegrams in queue count of maximum telegrams in the queue
TOS priority level (0=no priority) type of service in the telegram. See more here:
https://en.wikipedia.org/wiki/Type_of_service
Encryption key key for secure IP communication along LogicMachines. Setting
Encryption key will enable encryption of routing telegrams. Reception of normal
telegrams will still work. Tunneling and non-secure routing is disabled if only secure
communication is enabled. All devices must have the same date/time set otherwise
encrypted telegrams will be rejected.
Enable only secure communication define either only encrypted communication is
accepted
IP > TP filter
Filtering table for telegrams going from IP network to KNX TP1 is located in this submenu.
To Next Page
Loading...
Need help?
General
