EMC2 VNX5500 - Page 45

Verifying system status 45
Figure 33 Blade LEDs
Verify that the DPE and SP system Status and Power LEDs, located on the front are solid blue or
green as shown Figure 34 and Figure 35 on page 46.
Figure 34 3U DPE LEDs
Verify that the SP Power LEDs on SP A and SP B located at the rear of the DPE are solid green and
the SP Fault LED is off as shown in Figure 35 on page 46.
Note: If any fault LEDs are on, or if any power LEDs remain flashing after approximately 15 minutes
of operation, contact your authorized service provider.
AC
AC
AC
AC
Blade enclosure front
Blade power LED
Blade fault LED
Blade power LED
Blade fault LED
VNX-000230
24
0
12345678910 11 12 13 14 15 16 17 18 19 20 21 22 23 24
0
14
0
3U, 25 2.5” drive DPE front
DPE fault/status DPE power
3U, 15 3.5” drive DPE front
DPE fault/status
DPE power
SAS SAS SAS SAS SAS SAS SAS SAS SAS SAS SAS SAS SAS SAS SAS
VNX-000238