February 2019
User Instructions
MAN-02-04-60-0350-EN Rev. 3
57
Section 7: Parameter Menu
Parameter Menu
7.14 Parameter Group: Profibus-DP (option)
PROFIBUS DP denes the technical and functional characteristics of a serial eld bus
system, which can be networked with distributed digital automation devices. PROFIBUS-
DP is designed for the data exchange at the eld level.
Central control devices such as PLC or PC communicate via a fast serial connection with
distributed eld devices such as input/output devices, valves and actuators.
Data exchange with these distributed devices is cyclical. The communication functions
required to that end -are dened by the PROFIBUS-DP basic functions in accordance with
EN 50 170.
NOTE:
The Probus-DP option is a hardware option with which you should already be familiar
upon ordering the actuator.
Subsequent installation of hardware components is possible but should only be performed
by a professional Bettis installer or specially trained personnel.
The Probus-DP interface is described in the separate manual "Probus-DP for SMARTCON
controllers".
7.15 Parameter Group: DeviceNet (option)
The DeviceNet eld bus® is based on the CAN protocol and was originally developed by
Rockwell Automation as an open eld bus. Today, DeviceNet falls under the responsibility
of ODVA (Open DeviceNet Vendors Association, Inc., http://www.odva.org) as an umbrella
organization. DeviceNet is dened in EN 50325 2 and in IEC 62026 3. DeviceNet is a
simple and powerful eld bus system for the lowest eld bus level to connect sensors and
actuators (slaves) with the associated controllers in a network.
The DeviceNet option is a hardware option with which you should already be familiar upon
ordering the actua- tor.
Subsequent installation of hardware components is possible but should only be performed
by a professional
Bettis installer or specially trained personnel.
The DeviceNet interface is described in the separate manual "DeviceNet for SMARTCON
controllers".
To Next Page
Loading...
Need help?
General
