Emerson Bettis RTS CL Series - Parameter Group: Position; Parameter Group: Binary Inputs

February 2019
User Instructions
MAN-02-04-60-0350-EN Rev. 3
43
Section 7: Parameter Menu
Parameter Menu
7.7 Parameter Group: Position
In addition to OPEN and CLOSED end positions, you may dene intermediate positions.
These can be used as feedback signals for the binary outputs or as target value for x
position approach.
CAUTION: CHANGING END POSITIONS
If you change the end positions (see Section 7.1, intermediate positions are retained
percentage-wise, i.e., the absolute positions of the intermediate positions change.
Table 10. Position Parameter Group
Menu Item
Sub Menu
Item
Poss.
Setting
Notes / Comments
P8.1 Position
Intermed.
pos.1
TEACHIN
0 - 100%
Position value of intermediate position 1
P8.2 Position
Intermed.
pos.2
TEACHIN
0 - 100%
see above
P8.3 Position
Intermed.
pos.3
TEACHIN
0 - 100%
see above
P8.4 Position
Intermed.
pos.4
TEACHIN
0 - 100%
see above
P8.5 Position
Emerg.
position
TEACHIN
0 - 100%
Position value of the emergency position
P8.6 Position Hysteresis 0,1 - 10,0%
Hysteresis range of intermediate positions. Within this
hysteresis, no repositioning occurs upon reaching the
intermediate positions (option: x position approach).
Furthermore, the output functions for position =
intermediate position are active within this range
(see P10.1)
7.8 Parameter Group: Binary Inputs
The controller is equipped with 5 freely congurable binary inputs. Please nd further
information on technical data of the binary inputs in Section 16.2. Binary inputs are also
effective during actuator control via Probus (option).
Default binary inputs are as follows:
• Input 1: OPEN
• Input 2: CLOSED
• Input 3: STOP
• Input 4: EMERGENCY OPEN
• Input 5: EMERGENCY Closed