Emerson PACSystems Versamax - Removing the NIU from the DIN Rail

PACSystems VersaMax Genius Network Interface User Manual Section 2
GFK-1535D Jan 2023
Installation 21
2.3.1 Removing the NIU from the DIN Rail
1. Turn off the power to the power supply.
2. If the NIU is attached to the panel with a screw remove the power
supply module. Remove the panel-mount screw.
3. Slide the NIU along the DIN rail away from the other modules
until the connector disengages.
4. With a small flathead screwdriver, pull the DIN rail latch tab
outward while tilting the other end of the module down to
disengage it from the DIN rail.