Emerson PACSystems Versamax - Removing an Expansion Receiver Module; Expansion Rack Power Sources

PACSystems VersaMax Genius Network Interface User Manual Section 2
GFK-1535D Jan 2023
Installation 25
2.6.1 Removing an Expansion Receiver Module
1. Make sure the rack power is off.
2. Un-install the Power Supply module from the Expansion Receiver
Module.
3. Slide the Expansion Receiver Module on the DIN rail away from
the other modules.
4. Using a small screwdriver, pull down on the tab on the bottom of
the module and lift the module off the DIN rail.
2.6.2 Expansion Rack Power Sources
Power for module operation comes from the Power Supply installed on
the Expansion Receiver Module. If the expansion rack includes any Power
Supply Booster Carrier and additional rack Power Supply, it must be tied
to the same source as the Power Supply on the Expansion Receiver
Module.