Table 5-6: LED Error Codes
Code Error type
1 FPROM
2 HREG
3 Software
4 Other memory error
5 System
6 Display
7 Aux
8 FF stack
9 Tankbus
10 Host communication
11 Data manager
12 Configuration
Example
In case of a device error, the red LED will repeat a flash sequence that corresponds to the
particular type of error that occurred. For example, in case of a Display error (code=6), the
LED will show a sequence of 6 flashes followed by a 5 seconds pause. After the pause the
flashing starts over again in the same manner. This flash/pause sequence will be
continuously repeated.
Display error (code 6) appears with the following Error LED (red) flash sequence as
illustrated in Figure 5-5:
Figure 5-5: Error Code Flash Sequence
A. Seconds
Related information
Error messages
Operation Reference Manual
December 2019 00809-0100-2410
76 Reference Manual
To Next Page
Loading...
