6. In the Probe window, check configuration of Probe Type. The following Probe Types
are available:
• Rigid twin
• Flexible twin
• Coaxial, coaxial HP/C, coaxial HTHP
• Coaxial Large, Coaxial Large HP/C
• Rigid single, rigid single HTHP/HP/C, rigid single PTFE
• Flexible single, flexible single HTHP/HP/C, flexible single PTFE
The transmitter automatically makes some initial calibrations based on the selected
Probe Type. Normally, the Probe Type is pre-configured at the factory.
7. Check the entered Probe Length. See Probe length for further information.
8. In the Geometry window, set the tank geometry parameters.
a) Enter the Tank Height. See Tank height for further information.
b) Select the Mounting Type.
Reference Manual Configuration
00809-0100-4530 April 2019
Reference Manual 131
To Next Page
Loading...
