Table A-27: Rosemount 5303 Level for Solids Ordering Information (continued)
Options (include with selected model number)
Display
M1 Integral digital display ★
Communication
HR7 4–20 mA with digital signal based on HART 7 protocol ★
Hydrostatic testing
P1
(12)
Hydrostatic testing ★
Factory configuration
C1 Factory configuration (Configuration Data Sheet required with order, available at Emerson.com/
Rosemount)
★
Alarm limit configuration
C4 Namur alarm and saturation levels, high alarm ★
C5 Namur alarm and saturation levels, low alarm ★
C8 Low alarm
(13)
(standard Rosemount alarm and saturation levels) ★
Welding documentation
(14)
Q66 Welding Procedure Qualification Record Documentation
Q67 Welder Performance Qualification Record
Q68 Welding Procedure Specification
Safety certifications
QS Prior-use certificate of FMEDA Data. Only available with HART 4-20 mA output (output code H). ★
QT Safety-certified to IEC 61508 with certificate of FMEDA data. Only available with HART 4-20 mA
output (output code H).
★
Special certifications
Q4 Calibration Data Certification ★
Q8
(15)
Material Traceability Certification consistent with ISO10474-3.1:2013 / EN10204-3.1:2004 ★
QG GOST Primary Verification Certificate
Dye penetration test certificate
Q73 Certificate of Liquid Penetrant Inspection ★
Positive material identification certificate
Q76 Positive Material Identification Certificate of Conformance ★
Installation options
LS Long stud 9.8 in (250 mm) for flexible single lead probe to prevent contact with wall/nozzle.
Standard stud length is 3.9 in (100 mm) for probes 5A and 5B; 5.9 in. (150 mm) for probes 6A and
6B
★
BR 316L Mounting Bracket for 1½-in. NPT Process Connection (RA) (see Figure A-36)
Reference Manual Specifications and reference data
00809-0100-4530 April 2019
Reference Manual 341
To Next Page
Loading...
