274
Reference Manual
00809-0100-4026, Rev HA
Appendix H: Resource block
November 2014
Resource Block
MANUFAC_ID 10 0x00001151 Manufacturer identification number – used by an
interface device to locate the DD file for the resource.
DEV_TYPE 11 5400 Manufacturer’s model number associated with the
resource - used by interface devices to locate the DD
file for the resource.
DEV_REV 12 3 Manufacturer revision number associated with the
resource - used by an interface device to locate the DD
file for the resource.
DD_REV 13 1 Revision of the DD associated with the resource - used
by an interface device to locate the DD file for the
resource.
GRANT_DENY 14 0x00(0x00) Options for controlling access of host computers and
local control panels to operating, tuning, and alarm
parameters of the block. Not used by device.
HARD_TYPES 15 0x0001(Scalar Input) The types of hardware available as channel numbers.
RESTART 16 0x01(Run) Allows a manual restart to be initiated. Several degrees
of restart are possible. They are the following:
1 Run – nominal state when not restarting
2 Restart resource – not used
3 Restart with defaults – set parameters to default
values. See START_WITH_DEFAULTS below for which
parameters are set.
4 Restart processor – does a warm start of CPU.
FEATURES 17 0x0c1b(Unicode |
Reports | Soft W Lock |
Hard W Lock | Multi-bit
Alarm (Bit-Alarm)
Support | Restart/Relink
after FB_Action)
Used to show supported resource block options. See
Error! Reference source not found. The supported
features are: SOFT_WRITE_LOCK_SUPPORT,
HARD_WRITE_LOCK_SUPPORT, REPORTS, and
UNICODE
FEATURES_SEL 18 0x0000(0x0000) Used to select resource block options.
CYCLE_TYPE 19 0x0003(Scheduled |
Block Execution)
Identifies the block execution methods available for
this resource.
CYCLE_SEL 20 0x0000(0x0000) Used to select the block execution method for this
resource. The Rosemount 5600 supports the
following:
Scheduled: Blocks are only executed based on the
function block schedule.
Block Execution: A block may be executed by linking to
another blocks completion.
MIN_CYCLE_T 21 8000 Time duration of the shortest cycle interval of which
the resource is capable.
MEMORY_SIZE 22 16 Available configuration memory in the empty
resource. To be checked before
attempting a download.
NV_CYCLE_T 23 960000 Minimum time interval specified by the manufacturer
for writing copies of NV parameters to non-volatile
memory. Zero means it will never be automatically
copied. At the end of NV_CYCLE_T, only those
parameters which have changed need to be updated in
NVRAM.
FREE_SPACE 24 23.8095 Percent of memory available for further configuration.
Zero in a preconfigured device.
FREE_TIME 25 0 Percent of the block processing time that is free to
process additional blocks.
SHED_RCAS 26 640000 Time duration at which to give up on computer writes
to function block RCas locations. Shed from RCas shall
never happen when SHED_ROUT = 0
Parameter
Index
number
Default value Description
To Next Page
Loading...
