Emerson Site Supervisor User Manual

Appendix A: Alarm Advisories • A-3
Read Data Failed AI 02 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Read Data Failed AI 03 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Read Data Failed AI 04 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Read Data Failed AI 05 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Read Data Failed AI 06 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Read Data Failed AI 07 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Read Data Failed AI 08 System Alarm OnBoard Should be generated if sensors are configured but dis-
connected. If the advisory is reset, and the alarm/notice
condition still exists, the delay period will be used.
Advisories will return to normal if the command value
stays in the non-alarm/notice condition.
Network Device Offline System Alarm None The current controller could not find the specified
device controller. Device applications will generate an
Offline advisory if the device fails to communicate
after it is commissioned. When the advisory is gener-
ated, the status of the application will be offline.
Control Temp High Alarm Application
Alarm
AHU A control temperature advisory should occur after a
user specified time delay for both high and low tem-
perature conditions. This advisory should have associ-
ated parameters to allow the user to specify the high
and low advisory value and the delay. This advisory
should have separate setpoints for occupied and unoc-
cupied mode.
Alarm Items Category Cell Name Description

Emerson Site Supervisor Specifications

General

Brand	Emerson
Model	Site Supervisor
Category	Controller
Language	English