Site Supervisor Display Screens Site Supervisor Display • 4-7
The Site Supervisor may be configured to communi-
cate across an Ethernet computer network using TCP/IP
protocol. To enable Ethernet communication, you will
need to enter IP address information for the controller on
the Internet Values screen. The Internet Values screen
allows you to change, update, or view settings for Internet
(TCP/IP) networks connected to the Site Supervisor. Note
to record these settings so that you may refer to them later.
Once entered, press SUBMIT.
Default Values:
IP Address 192.168.0.250
Subnet Mask 255.255.255.0
Default Gateway 192.168.0.1
Once logged in, depending on user permissions, select
the desired category.
Figure 4-11
- Enter Internet Values (Setup Wizard on Factory-
New Units)
Figure 4-12 - Set Date, Time, and Zip Code
Figure 4-13 - Choose Desired Category
Icon Definition
Refrigeration Applications
Lighting Control Applications
HVAC Applications
Energy Applications
Other Applications
Table 4-2
- Site Supervisor Display Icons and Definitions
To Next Page
Loading...
