Cerabar S/Deltabar S Description of parameters (ToF Tool)
Endress+Hauser 113
UNIT VOLUME
Selection
Select volume unit.
Prerequisite:
• LINd. MEASURAND = pressure and volume
Options:
•l
•hl
•cm
3
•dm
3
•m
3
•m
3
E
3
•ft
•ft
3
E
3
•gal
•Igal
•bbl
•User unit, → see also the following parameter description for CUSTOMER UNIT V and
CUST. UNIT FACT. V.
Factory setting:
m
3
CUSTOMER UNIT V
Entry
Enter text (unit) for customer-specific volume unit.
You can enter a maximum of eight alphanumeric characters here. → See also CUST.
UNIT FACT. V
Prerequisite:
• LINd. MEASURAND = pressure and volume,
UNIT VOLUME = user unit
!
Note!
Only the first five characters are shown on the on-site display. For example, if "crates" is
specified as the customer-specific unit, "crate" is displayed.
If the unit contains a slash, up to eight characters can be shown on the on-site display.
The maximum number of characters in the counter is again limited to five. For example,
if "crates/m2" is specified as the customer-specific unit, "crate/m2" is displayed. In the
ToF Tool, all eight characters are displayed.
Factory setting:
_ _ _ _ _ _ _ _
CUST. UNIT FACT. V
Entry
Enter conversion factor for a customer-specific volume unit.
The conversion factor must be entered in relation to the SI unit "m
3
". → See also
CUSTOMER UNIT V.
Prerequisite:
• LINd. MEASURAND = pressure and volume,
UNIT VOLUME = user unit
Example:
– You want the measured value to be displayed in "buckets".
– MEASURED VALUE = 0.01 m3 i 1 bucket
– Entry CUSTOMER UNIT V: bucket
– Entry CUST. UNIT FACT. V: 100
– Result: MEASURED VALUE = 1 bucket
Factory setting:
1.0
ToF Tool, Table 8: OPERATING MENU → SETTINGS → BASIC SETUP "Level",
LEVEL MODE "Pressure linearized"
Parameter name Description
To Next Page
Loading...
