Endress+Hauser cerabar S - Page 122

Description of parameters (ToF Tool) Cerabar S/Deltabar S
122 Endress+Hauser
DENSITY UNIT
Selection
Select density unit.
Prerequisite:
• COMB. MEASURAND = %-height and %, CALIBRATION MODE = dry
• COMB. MEASURAND = %-height and volume, CALIBRATION MODE = dry
• COMB. MEASURAND = %-height and mass, CALIBRATION MODE = dry
• COMB. MEASURAND = height and %, CALIBRATION MODE = dry
• COMB. MEASURAND = height and volume, CALIBRATION MODE = dry
• COMB. MEASURAND = height and mass, CALIBRATION MODE = dry
Options:
• g/cm
3
•kg/dm
3
•kg/m
3
• US lb/in
3
• US lb/ft
3
Factory setting:
kg/dm
3
ADJUST DENSITY
Entry
Enter density of fluid.
Prerequisite:
• COMB. MEASURAND = %-height and %, CALIBRATION MODE = dry
• COMB. MEASURAND = %-height and volume, CALIBRATION MODE = dry
• COMB. MEASURAND = %-height and mass, CALIBRATION MODE = dry
• COMB. MEASURAND = height and %, CALIBRATION MODE = dry
• COMB. MEASURAND = height and volume, CALIBRATION MODE = dry
• COMB. MEASURAND = height and mass, CALIBRATION MODE = dry
Factory setting:
1.0
HEIGHT UNIT
Selection
Select level unit.
Prerequisite:
• COMB. MEASURAND = %-height and volume, CALIBRATION MODE = dry
• COMB. MEASURAND = %-height and mass, CALIBRATION MODE = dry
• COMB. MEASURAND = %-height + %, CALIBRATION MODE = dry
Options:
•mm
•dm
•cm
•m
•inch
•ft
•User unit, → see also the following parameter description for CUSTOMER UNIT H
and CUST. UNIT FACT. H.
Factory setting:
m
ToF Tool, Table 9: OPERATING MENU → SETTINGS → BASIC SETUP "Level",
LEVEL MODE "Height linearized"
Parameter name Description